USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 23 of 36
2.70 THP VS Pump Family
IS3206VSP3 Rev-A
Buttons
Screen Used
Comments
12.
+ -
Enable or Disable Low Temp Operation
< >
Move to next menu item
13.
+ -
Set temperature to activate Low Temp Operation
< >
Move to next menu item
Note:
When the pump is stopped and the ambient temperature drops below the operation temperature set point,
the pump will prime and then run at the Max allowed speed setting for 8 hours. Low temperature operation is
not
active when the pump is being remotely controlled.
Low temperature operation is NOT intended to protect the
pump, system plumbing, or pool from freezing.
If Low Temp Operation is disabled, the temperature setting screen is
not shown.
14.
+ -
Use to enable or disable password protection
< >
Move to next menu item
15.
+ -
Use to set password timeout
< >
Move to next menu item
Note:
This sets the amount of time from the last button activation after the system has been unlocked to the point
where the system becomes locked again.
16.
+ -
Use change system password if desired
< >
Move to next menu item
17.
+ -
Use to set selected password character
< >
Move to next password character/next menu item
18.
+ -
Use to set selected password character
< >
Move to next password character/next menu item
Note:
If the new password is not confirmed correctly, then the user will be prompted again to confirm the password.
If a mistake is made when entering the password, pressing Stop/Resume will cancel the action.
After a password has been set, follow the procedure below to unlock the system from the Home screen.
19.
+ -
Use to set selected password character
< >
Move to next password character
Note:
When password protection is enabled and the timeout has elapsed, the user will be prompted to enter the
password to unlock the display when any of the display buttons (other than Stop/Resume) are selected. The user
may use Stop/Resume to stop the pump and resume normal operation without having to enter the password. The
factory default password is 1234. If the password has been changed, it may be reset to factory default by pressing
and holding the Speed 1 and Speed 4 buttons at the same time while powering on the drive, or by resetting all
parameters in the Configuration Menu. If a mistake is made when entering the password, pressing Stop/Resume will
cancel the action. If the pump is being controlled by a Hayward or third party pool control, the pump display can be
locked by the password, however, the pump will respond to any and all commands being sent from the pool control.
Low Temp Setting
4ºC (39.2ºF)
Low Temp Operation
Disabled
Password Protection
Disabled
Password Timeout
0:15
System Password
+ change or > skip
System Locked
Password: 0___
Set Password
0___
Confirm Password
0___