Hayward HRSN4A, Installation, Operation And Maintenance Instructions, Page: 4 / 32

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
HRSN4FSIOM Rev E ECR 132V
Page 4 of 32
Hayward Flow Control
1-888-HAY-INDL (1-888-429-4635)
www.haywardflowcontrol.com
Control Voltage Torque Switches Fail Safe Local Control Station IOM Wiring Diagram Page
On/Off 24VDC/VAC XTS/TS FS None This IOM 28
Proportional 24VDC/VAC XTS/TS FS None This IOM 29
On/Off 120VAC * XTS/TS FS None This IOM 30
Proportional 120VAC * XTS/TS FS None This IOM 30
On/Off 230VAC * XTS/TS FS None This IOM 30
Proportional 230VAC * XTS/TS FS None This IOM 30
* Requires use of a transformer to convert supply voltage to 24V .
ACTUATOR OPTIONS
Below are Terms and Definitions used throughout this manual .
1 . XTS/TS product manufactured without/with Torque Switches .
2 . FS product manufactured with Fail Safe built-in .
3 . LCS is an industry acronym for a Local Control Station .
4 . CW is Clockwise and CCW is Counterclockwise .
CONVENTIONS USED IN THIS MANUAL
Use this table to efficiently select the actuator and wiring diagram you require .
ACTUATOR SPECIFICATIONS
(20 SERIES)
Supply Torque Output ( lbf-in / Nm) 3540 / 400 5310 / 600 7080 / 800 8850 / 1000
24VAC
-
24VDC
Current Draw (Start / Run / LRA) 7.0A / 5.8A / 15A 7.0A / 5.8A / 15A 7.0A / 5.8A / 15A 10.5A / 7.8A / 22A
Speed (90°) DC-60Hz/50Hz, seconds 21 / 21 28 / 28 34 / 34 34 / 34
Motor - 24V DC Perm Magnet 2 Pole Brush 40W 40W 40W 90W
On/Off /
Proportional
Duty Cycle (IEC60034) 75% (S2-15 min) / 75% (S4-75%)
Motor Protection, Temp / Class All - 130°C / Class B
Motor Starts, per hour, Max All - 600
Requires 120:24 Transformer Pack, 500VA HRSBBC120-500 HRSBBC120-500 HRSBBC120-500 HRSBBC120-500
120VAC
Transformer Current Draw (Inductive) 1.75A 1.75A 1.75A 2.63A
Speed (90°) 60Hz / 50Hz, seconds 21 / 21 28 / 28 34 / 34 32 / 34
Motor - 24V DC Perm Magnet 2 Pole Brush 40W 40W 40W 90W
On/Off /
Proportional
Duty Cycle (IEC60034) 75% (S2-15 min) / 75% (S4-75%)
Motor Protection, Temp / Class All - 130°C / Class B
Motor Starts, per hour, Max All - 600
Requires 230:24 Transformer Pack, 500VA HRSBBC230-500 HRSBBC230-500 HRSBBC230-500 HRSBBC230-500
230VAC
Transformer Current Draw (Inductive) 0.55A 0.55A 0.55A 0.55A
Speed (90°) 60Hz / 50Hz, seconds 21 / 21 28 / 28 34 / 34 32 / 34
Motor - 24V DC Perm Magnet 2 Pole Brush 40W 40W 40W 90W
On/Off /
Proportional
Duty Cycle (IEC60034) 75% (S2-15 min) / 75% (S4-75%)
Motor Protection, Temp / Class All - 130°C / Class B
Motor Starts, per hour, Max All - 600
All
Environmental Rating NEMA 4/4X & IP67
Electrical Entry (2) 3/4" EMT or Polyamide gland
Control On/Off or Proportional
Auxiliary Switch - End of Travel (2) Form A Volt-Free, Rated 10A @ 250vac
Ambient Operating Range -22°F to +158°F / -30°C to +70°C
Humidity Range 0-95% RH
Altitude Limit 9850 ft / 3000 m
BATTERY
SPECIFICATIONS
Type Lithium Ion 22.2v pack with charge / discharge control
Cell Arrangement Bank of 8 (eight) x 2.8V w/ logic control
Service Life - @ Rated Torque Cycle Drain 10,000 cycles @ 5% Stored energy drain per cycle
Enclosure Entire Battery System under Main Cover
HRSN4A HRSN4B HRSN4C HRSN4D
HRSN4A~4D (20 SERIES)
TECHNICAL INFORMATION
Back to TOC