USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
HRSLCSSPLMNTIOM Rev A
Page 6 of 42
Hayward Flow Control
1-888-HAY-INDL (1-888-429-4635)
www.haywardflowcontrol.com
HRCK and HRCP advanced stand-alone actuators are designed to be installed in new contruction sites or existing
sites where there are NO existing local control capabilities. These single phase and low voltage actuators have
several versions that continue to add more features and options than the standard actuator range.
Moreover, these units incorporate a Local Control Station (LCS) to facilitate operating the actuator. Having this
feature allows operation of the actuator WITHOUT having an existing PLC or BAS based analog controller while also
providing operability with existing external controls.
Inside the actuator/LCS package, you will find:
1 . Integral
Local Control Device
. This series is designed to operate in Local mode (control knobs or buttons located
on the face of the LCS, which is an integral part of the actuator) or in Remote mode, which utilizes commands from
a PLC, BAS or other volt-free contact (dry contact) automation device.
WD75TS
Apply no external power
A. While in Remote mode, the Remote
devices must have volt-free contacts
(dry contacts) which will switch the
actuator’s internal 24vac power
supply to generate commands to
drive CW or CCW.
B. While in Local mode, the actuator
responds to the position of the
controls located on the face of the
integral LCS.
C. The Mode switch (CK Series) is operated
by a removable key which, when
removed, will prevent unauthorized
changes in the operating mode
(Local, Off or Remote).
D. The Mode button (CP Series) is
protected by a lockable cover
plate which, when locked, will
prevent unauthorized changes in
the operating mode (Local, Off or
Remote).
24V~230V On/Off Control
LCS, XTS/TS
HRCK, HRCP 2A~6A
THEORY OF OPERATION
Back to TOC