with the first Body of Water, you’ll follow the same instructions for the second Body of Water, if previ-
ously selected. Configured equipment like a VSP and heater will be shared among both.
What is the Body of Water type?
Select the type of Body of Water that you would like to configure.
The choices are Pool and Spa.
Name of Body of Water
- Selecting the box will allow you to edit the name. During initial
configuration, the box will be blank. Select the box and then use the keyboard to enter the
desired name of the body of water.
Name Filter Pump
- Touch the box and use the keyboard to name the filter pump.
What Type of Pump?
- Depending on your answer, the VS Omni will use one Smart Relay (single
speed pumps), two Smart Relays (two speed pumps) or the low speed communication bus (VSP
pumps) for pump control. Select the type of pump and advance.
If one speed or two speed pump is selected:
Which Relay is it Wired to?
If using a single speed or two speed pump, you’ll be asked
which relay(s) is wired to the pump. If a value is already shown in the box(es), advance to
the next screen. If no value is shown, selecting the box will bring you to a table showing
all detected relays. Select the proper relay(s) from the table and touch the Done button
to proceed. The relay(s) should now be shown in the box(es) and you can advance to the
next screen to continue the pump configuration.
Filter Pump Off for Valve Change?
When Yes is selected, the pump will shut off for 35
seconds whenever a valve changes position.
Flow Monitoring Enabled?
Requires use of a Hayward flow switch.
This feature will help
protect the filter pump from damage due to no flow. When Yes is selected, the VS Omni
will monitor the state of water flow when the filter pump is on. If no flow is detected for
more than 15 minutes, the VS Omni will shut down the pool pump and will indicate an
error. The error will be cleared the next time the pump is turned on.
Would You Like to Enable Priming?
Select whether you want the filter pump to prime
when turned on. This will turn the pump on at high speed for a set duration to establish
normal water flow every time the pump is activated after being off for at least 30 seconds.
NOTE: this option only appears if the filter pump is configured as a two speed pump.
If Yes is selected:
Enter Priming Duration: This is the number of minutes that the pump will prime
before returning to the scheduled speed. Select 0-15 minutes.
Freeze Protection Enabled?
Freeze protection is used to protect the pool and plumbed
equipment against freeze damage during cold temperatures. If freeze protection is en-
abled AND the air temperature falls below the freeze threshold, the VS Omni will turn on
the filter pump to circulate the water.
If Yes is selected:
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
28
