5. Install lens
Failure to install a new lens gasket could result in a leak that can damage the BPCUS11120
and cause serious injury or death due to electrical shock.
Before installing the lens, clean any
old gasket residue from the light fixture. The surface must be clean for the new gasket to seat
properly. Install your new replacement gasket onto the glass lens. Set the lens and cover plate
on the light housing and secure by tightening the screws and/or clamp, allowing the gasket to
seal evenly.
6. Test light fixture in water
Submerge the assembled light fixture in the water and visually check that air bubbles are not
escaping from the gasket area or at the power cord entrance. If bubbles appear, immediately
remove the light fixture from the water and re-seat the gasket and lens. Continue the installation
only if there are no air leaks.
7. Install light fixture into niche
If there are no leaks, complete the installation by wrapping the cord around the light fixture in
the same manner as when it was removed. Secure the light fixture to the niche using the original
or equivalent fasteners.
8. Inspect
Turn power on to the lamp at the main panel. With the light on, check for air bubbles exiting
the light housing. Leave the lamp on for 30 minutes and continue to inspect. If there are no air
bubbles, the housing is watertight and installation is complete.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
4
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
4
