18
For scarifying
Correct cutting blade fitted already thus no need for extra
installation.
For raking
•
Use an Allen key to replace the working roller.
•
Turn the machine over and loosen the two screws (A) on
the bearing shell (C) (fig. 8).
•
Lift the roller on the bearing side and pull it out of the
drive (B) (fig. 8).
•
Lift the complete roller upwards out of the machine
•
Pull the bearing shell (C) (fig. 8) off the roller. Fit the
bearing shell (C) to the new work roller (fig. 9)
•
Slide the square drive bushing of the new roller onto the
drive axle (B) of the machine (fig. 9)
•
Fit the other end of the work roller with the bearing shell (C)
into the corresponding mount on the machine
•
Fasten the roller with the two screws (A) and tighten these
with the Allen key (fig. 9). Then tum the ma chine back
over again
OPERATING INSTRUCTIONS
Always keep to instructions on safety and current
rules and regulations.
HINTS AND SUGGESTIONS
How to use the scarifier (using scarifying roller 10)
•
By scarifying you remove the hardened surface, grass felt
and flat-growing weeds and the crusted over grass roots
are loosened up. The lawn will start to breath again and
assimilate the nourishing substances, oxy gen and water.
This also prevents the establishing of bacteria in the lawn
felt during the wintertime.
•
Cut the grass to a height of about 40 mm before
scarifying. The lawn must be dry when using the machine
The best time for an scarifying is any time during the
vegetative season, from end April through to Septem ber.
Scarify it at least once a year. We recommend us ing a
fertilizer straight after airing if you want a green carpet.
fig. 8
fig. 9
11
A
C
B
14
10
A
C
14
B
