2
DC Adapter Port
Insert the power jack of the power adapter into this port.
3
LAN Port
The Access Point’s LAN port is where you connect to your LAN’s network
devices.
4
Reset
The Reset button allows you to do one of two things.
1)
If problems occur with your Access Point, press the reset button with a
pencil tip (for less than 5 seconds) and the Access Point will re-boot
itself, keeping your original configurations.
2)
If problems persist or you experience extreme problems or you forgot
your password, press the reset button for longer than 5 seconds and the
Access Point will reset itself to the factory default settings (warning:
your original configurations will be replaced with the factory default
settings).
Install Access Point with Signal Booster
To connect the Access Point with the Signal Booster, please follow the ways
described below.
1.
Connect the Access Point to one side of the connector cable in the package.
2.
Connect the other side of the connector cable to the signal booster.
3.
Screw the dipole antenna in the package to the signal booster.
4.
Power on the signal booster.
5.
Adjust the output power range from the switch in the booster for the best
signal strength.
1
2
3
