w w w . h a w k e y e e l e c t r o n i c s . c o m
N
OTICE
:
In calm water, the sonar sensor can be set at a level which will
provide the maximum amount of sonar coverage. In rougher water,
the sonar sensor may need to be lowered into the water further to
provide stabilized readings.
USING THE SONAR SENSOR WITH THE FLOAT
1. Toss the sonar sensor and float assembly
into the water at your desired fishing
location. To toss, place the sonar sensor
and float in your hand, and pitch underhand.
Do not throw the sensor by the cable as this
will cause unrepairable damage. Before
tossing, be certain that the cable is free from
tangles and is not wrapped around anything.
2. Use a pole to guide the sonar sensor to a
desirable position or add a float kit (P/N:
3000.94) on the cable to allow the cable to
float on top of the water.
3. To retrieve the sonar sensor and float,
simply pull in the cable being certain to neatly wind up the excess cable.
I
MPORTANT
:
Do not allow the cable to
sink to the bottom as it may
become entangled in
debris.
REMOVING THE SONAR SENSOR FLOAT
If you find that you do not have a need for the sonar sensor float, it can be
removed as follows:
1. Remove the rubber stopper from the cable by sliding the safety strap toward
the headphone-style plug and gently working it over plug.
2. Slide the cable through the center of the float toward the plug and gently
work the plug through the center of the float in a rocking motion.
USING THE SIDESCAN ADAPTER
Your fish finder includes a combination Side-Scan adapter & mounting bracket
for the Sonar Sensor.
