w w w . h a w k e y e e l e c t r o n i c s . c o m
2. Release the Keys.
3. To set the units to FEET press the “UP” key. “FT” will flash on the Display.
4. To set the units to METERS press the “DOWN” key. “M” will flash on the
Display.
5. The display will return to the normal operation mode automatically after five
seconds.
IMPORTANT:
Install and test the display in the desired
mounting location before attempting the
transducer installation.
TRANSOM MOUNTING THE TRANSDUCER
I
MPORTANT
:
Transom mounting the transducer is suitable for most
vessels and generally offers the best performance. If you
decide to glue the transducer in-hull, you MUST test the
location on water prior to permanently affixing it to the hull.
If you cannot obtain satisfactory readings during on water testing you
will need to transom mount the transducer, or switch to a custom
transducer. If you have determined that you are going to try to glue
the transducer in-hull, please skip to the next section.
Tools & Supplies Required for Installation
•
Power Drill
•
5/8” (16 mm) drill bit, hole saw or spade bit
•
1/8” (3 mm) drill bit
•
9/64” (4 mm) drill bit
•
Marine Sealant/Caulk
•
30 Grit Sandpaper
•
“Phillips” Screwdriver
•
Pencil
•
Tie Wraps
•
Water Based Antifouling Paint
•
Masking Tape
Transom mounting is suitable for the following vessels:
•
Outboard, inboard/outboard, single inboard, or jet-drive propulsion.
