Hawkeye Mfg AGCO RoGator A Series, Installation Manual

Page: 10 / 54

CHAPTER 2
6 Hawkeye® 2 Installation Manual for AGCO RoGator A/B-Series (RG900, RG1100, RG1300)
INSTALLATION OVERVIEW
The recommended process for installing the Hawkeye® 2 nozzle control system is as follows:
1. Confirm Hawkeye® 2 kit contents. See the
Kit Contents section on page 7.
2. Replace existing strainer with an 80 mesh (or finer) strainer. See Chapter 3, Installation Preparation .
3. Remove spray tips and flush each section individually for a minimum of 20 seconds to thoroughly flush the
boom.
4. Install provided nozzle bodies as needed. See Chapter 4, Nozzle Body and Nozzle Control Valve Installation .
5. Mount Hawkeye® 2 nozzle control valves.
6. Route and connect the inner, mid, and outer boom cables (as applicable). See the
Boom Cable Routing and
Connections (Inner, Middle, and Outer Boom Cables) section on page 22.
7. Mount the RCM - Sprayer. See Chapter 5, Install the Hawkeye® 2 RCM - Sprayer .
8. Route and connect chassis and RCM - Sprayer cables. See Chapter 6, Chassis Cable Installation .
9. Review the Post-Installation Notes for machine configuration tips.
REQUIRED COMPONENTS
The following components must be installed with the Hawkeye® 2 nozzle control system:
• Updated software on field computers or control monitors and other ECUs. Contact your local AGCO dealer for
the latest software.
• PWM pump control valve
• Raven compatible flow meter
• Raven compatible pressure transducer
• 80 mesh (or finer) strainer
NOTE: A fan or cone style spray tip is recommended for the Hawkeye® 2 system to operate properly. Air
induction tips are not recommended for use with the nozzle control system.
TOOLS AND MATERIALS NEEDED
The following tools are recommended for completing the installation:
• SAE and metric sized wrenches and tools
• 1-1/2” hole saw
• Drill bit set and drill
• CorrosionX HD (recommended) or other dielectric contact treatment
• Cable ties (supplied)
• Phillips screwdriver
• Side cutters
POINT OF REFERENCE
The instructions provided in this manual assume the installer is standing behind the machine, looking toward the
machine cabin.