14
Topside Control Operations Guide
Temperature Control (80ºF – 104ºF / 26ºC – 40ºC)
The last measured water temperature is constantly displayed. The water temperature
displayed is current only when the pump has been running for at least two minutes.
To display the set temperature, press ‘Warm’ or ‘Cool’ once. To change the set temperature,
press a temperature button again before the display stops flashing. Each press of ‘Warm’ or
‘Cool’ will adjust the set temperature.
After three seconds, the display will stop flashing and begin to display the current spa
temperature.
Jets 1
Press ‘Jets 1’ to turn the first pump on or off and to shift between low and high speeds. The
high speed turns off automatically after 15 minutes. The low speed turns off automatically
after four hours. Low speed may run automatically at times – this is normal.
Jets 2/Jets 3 (If equipped)
Press the corresponding button once to turn the device on or off. The device will turn off
automatically after 15 minutes.
Light
Press ‘Light’ to operate the spa lights. The spa lights will turn off automatically after four hours.
Mode
Mode is changed by pressing ‘Warm’ and then pressing ‘Mode’ if the topside control unit has
a ‘Mode’ button. Otherwise, mode is changed by pressing ‘Warm’ and then pressing ‘Light.’
• Standard Mode (recommended) –
Maintains set temperature. ‘Std’ or ‘St’ will be
displayed momentarily when spa is switched into Standard Mode.
• Economy Mode –
Heats the spa to the set temperature only during filter cycles or if
‘Jets 1’ is on high speed. ‘Ecn’ or ‘Ec’ will display when water temperature is not
current, and will alternate with water temperature when the pump is running.
• Sleep Mode –
Heats the spa to within 20ºF / 10ºC of the set temperature only during filter
cycles. ‘Slp’ or ‘SL’ will display when water temperature is not current, and will alternate with
water temperature when the pump is running.
