MPS3004 / RS4004 AUDIO SYSTEMS
INSTALLATION GUIDE
HAWG WIRED
PAGE 9
NEWARK, CA
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
S
S
[
[
C
C
O
O
N
N
T
T
I
I
N
N
U
U
E
E
D
D
]
]
TESTING AND TUNING THE SYSTEM
16.
RE-CONNECT THE POSITIVE (+) SIDE OF THE BATTERY, FOLLOWED BY THE NEGATIVE (-) SIDE.
WARNING: DO NOT INSTALL THE IN-LINE FUSE UNTIL AFTER THIS STEP.
THIS IS A GOOD TIME TO RE-CHECK YOUR CONNECTIONS BEFORE INSTALLING THE FUSE. MAKE SURE THAT THE
CONTROL CABLE IS COMPLETELY SEATED AND LATCHED IN THEIR RESPECTIVE CONNECTOR, AND THAT POWER AND
GROUND ARE PROPERLY CONNECTED TO THE MAIN AMPLIFIER.
17.
INSTALL THE 30 AMP ATC FUSE INTO THE IN-LINE FUSE HOLDER ON THE POWER WIRE.
NOTE: IF THE FUSE DOESN’T BLOW WHEN YOU PLUG IT IN, YOU’VE PASSED THE INITIAL SMOKE TEST.
18.
PERFORM A BASIC SYSTEM TEST. TURN THE KEY TO THE ACCESSORY POSITION AND VERIFY
THAT THE AMPLIFIER(S) POWER UP (LED ON EACH COMPONENT SHOULD LIGHT) AND THAT THE
SPEAKERS FUNCTION PROPERLY. IF NOT, PROCEED DIRECTLY TO “TROUBLESHOOTING” IN THE
USER GUIDE SECTION.
19.
CONFIGURE, TEST, AND TUNE YOUR SYSTEM BY FOLLOWING THE “TEST AND TUNE”
INSTRUCTIONS GIVEN IN THE “USER GUIDE” SECTION OF THIS MANUAL. WHEN YOU’VE
COMPLETED THESES INSTRUCTIONS AND ARE READY TO ROCK AND ROLL, RETURN HERE TO
COMPLETE THE INSTALLATION.
NOW IT’S TIME TO START ROTATING KNOBS AND FLIPPING SWITCHES TO GET THE MOST OUT OF YOUR NEW SYSTEM. IF
YOU RUN INTO ANY SNAGS ALONG THE WAY, LET US KNOW SO WE CAN HELP GET YOU UP AND RUNNING.
WRAPPING IT UP
20.
WITH THE IGNITION OFF, CAREFULLY INSTALL THE FAIRING COVER, ENSURING THAT EACH
ATTACHING SCREW GOES BACK INTO THE HOLE IT CAME OUT OF. ONCE YOU HAVE EVERYTHING
LINED UP AND ALL SCREWS LOOSELY INSTALLED, TIGHTEN EACH SCREW IN AN EVEN PATTERN
TO AVOID BINDING.
WARNING: AVOID OVER-TIGHTENING; PLASTIC THREADS HAVE A TENDENCY TO PULL OUT EASILY. REFER TO
MANUFACTURER INSTRUCTIONS IF NECESSARY.
21.
INSTALL THE SEAT, TAKING CARE NOT TO DAMAGE OR PINCH YOUR FACTORY WIRING HARNESS
OR NEW AMPLIFIER POWER WIRE.
TIP: BE SURE THAT BOTH BATTERY TERMINALS ARE CONNECTED AND TIGHT, AND THAT ANY GAS TANK BOLTS
LOOSENED EARLIER ARE NOW TIGHT. REFER TO MANUFACTURER INSTRUCTIONS IF NECESSARY.
76 22.
PERFORM A FINAL SYSTEM TEST. TURN THE KEY TO THE ACCESSORY POSITION AND VERIFY
THAT ALL COMPONENTS STILL FUNCTION PROPERLY.
23.
PERFORM A TEST RIDE AND AGAIN VERIFY THAT THE SYSTEM IS OK, AND THAT YOUR FRIENDS
ARE SUFFICIENTLY JEALOUS.
TIP: JUSTIN WOULD LIKE TO REMIND YOU TO CHECK YOUR TIRE PRESSURE, AND FROM THE ENTIRE HAWG
WIRED TEAM, THANKS FOR MAKING THIS POSSIBLE, KEEP THE RUBBER SIDE DOWN, AND CRANK IT!
