English
13
OPERATION
Before using your kettle
If you are using the kettle for the first time, it is recommended that you should clean
your kettle before use by boiling a full kettle of water twice and then discard the
water. Wipe the surface with a damp cloth.
Note:
The max capacity of the kettle is 1.5 liter.
Dry-boil protection
If you accidentally let the kettle operate without water, the dry-boil protection will
automatically switch off the power. If this occurs, allow the kettle to cool before filling
with cold water and re-boil.
Use your kettle
1. To fill the kettle, remove it from the power base and open the lid by pressing the
lid release button. Fill with the desired amount of water, and then close the lid.
Alternatively, the kettle may be filled through the spout. The water level should
not exceed MAX level or be below MIN level. Too little water will result in the
kettle switching off before the water has boiled.
Note:
Do not fill the water over the maximum level, as water may spill out of
the spout when boiling. Ensure that the lid is firmly in place before plugging the
power outlet.
2. Place the kettle on the power base. Connect the plug into a power outlet. Turn
on the switch, the indicator will light up. Then the kettle will start to boil the
water. It will switch off automatically once the water has boiled. You can shut off
the power by turning off the switch at any moment during boiling. If you want to
boil water again, only turn on the switch directly to restart the kettle.
Note:
Ensure that switch is free of obstructions and the lid is firmly closed, the
kettle will not turn off if the switch is constrained or if the lid is open.
3. Lift the kettle from the power base and then pour the water.
Note:
Operate carefully when pouring the water from your kettle as boiling
water may result in scalding, besides, don’t open the lid while the water in the
kettle is hot.
4. The kettle will not re-boil until the switch is pressed again. The kettle may be
stored on the power base when not in use.
Note:
Always disconnect the power supply when not use.
