C-VS-2000-DUR-1_INST_8-17
Reattach O.E.M. harnesses and
plugs.
OR
Manual park release can be mounted to
back of console using 10-32 x 1/2"
machine screws and Keps nuts
.
Note: In this location, the release
assembly could possibly get damaged
when seat is slide reward.
If mounting a C-HDM-204 or 214 side
computer mount, use the existing 1/4"
hex nuts with 1/2" hex bolts and flat
washers in upper side extrusion.
Use 1/4” x 3/4" hex head bolts and flat
washers for bottom mounting.
Carefully place top faceplate onto
console and attach with # 8 x 3/8”
Torx head screws. Slide shifter back
on and plug in shifter boot to OEM
harness
Tighten Allen head bolt to OEM
shifter stalk. (9/64” Allen wrench)
Snap shifter boot down into shifter
boot plate
Run wiring as needed. Mount face
plates and accessories into console
with # 8 x 3/8” Torx head screws.
Screws supplied with equipment
brackets and accessories.
Manual park release needs to be looped
inside console and located so access can
be done by removing cup holder.
Note: See owner’s manual section
“What to do in Emergencies”
for more Park Release information.
Install computer mount assembly
and make final adjustments.
Installation is now complete