KK-C-VAK_INST_10-07
During Kwik-Kit installation you will
be prompted to return to the KK-C-
VAK instruction to attach the hose to
the vent adapter brackets. Route hose
into ceiling holes and cut off any extra
slack.. Attach the hose to the vent
bracket using a 3” hose clamp
Align the three mount holes of the vent adapter cover
with the pre-punched holes in ceiling.
Attach each vent to ceiling using #8 x 3/8” flat head
sheet metal screws.
(Screws included with standard Kwik-Kit hardware)
After Aluminum insert is installed and tested,
attach cover plate to bench / wall to cover
OEM Rear AC/Heat Unit using #10 Sheet
metal screws.
Check that airflow through hoses is
working properly.
With hoses routed to locations, proceed
to install Kwik-Kit unit until you come
to the ceiling instructions. Be sure not
to puncture the hoses with screws, drill
bits, etc…
Attach ceiling pieces on Kwik-Kit,
routing hoses into the corresponding
holes in Kwik-Kit ceiling. Pull through
to minimize slack.
Check airflow again.
