HAVERLAND UK LIMITED
Challenge House, Sherwood Drive
Bletchley, MK3 6DP
Tel: 0030 3651940
– Fax: 01672 811944
15/11/2020
11. ADVANCED FUNCTIONS
To access them, the radiator must be first on the AUTO setting, therefore, press the button until you see
“AUTO” on the top left corner of the display.
Now press and hold
, 4 horizontal lines will appear, and number 1 will be displayed on the right-hand
corner. Use the UP or DOWN buttons until
End
is on the display, press and hold
4 horizontal lines
will appear (you will see a small hand, ºC and a number 1 on the right-hand corner), use the UP or DOWN
to select between the different functions:
•
Parameter 1
–
This setting allows to change from degrees Celsius (C) to degrees Fahrenheit (F).
•
Parameter 2
–
This allows you to activate or deactivate the “Pilot wire” function. The function is
deactivated by default. This function is only available in France
•
Parameter 3
–
Information on the v
ersion of the device’s firmware.
•
Parameter 4
–
This setting allows you to correctly set the output power of your unit. You first
press OK and then use the UP/DOWN arrows to select the output power and press OK to
confirm.
•
Parameter 5 - This allows you Reset your unit to factory settings. You first press OK (you will see
“FAct”
on the display and then just press and hold the OK button to reset it. The unit will return
to manual mode with the factory pre-set temperature (20 ºC).
•
Parameter 6
–
End this allows you to exit the Advanced functions.
