Fitting a Collar
4
Be sure the Fence is turned off at the Controller
(see Turning the Trigger Zone Off/On in the
Instruction Manual).
With your dog standing comfortably, position the Collar high on your dog’s neck, underneath
the chin with the Probes facing upward and centered on your dog’s neck. The Havahart
®
logo
should be right side up when you look at your dog.
Make sure the Probes maintain contact with your dog’s skin.
- Collar is factory-installed with Long Probes for thick or long-haired dogs.
- Short Probes for short-haired dogs are included.
- To change the Probes, simply unscrew the Long Probes and replace them.
Finger-tighten the Probes. Do not over-tighten.
Adjust the Collar to fit snugly but not tightly. You should be able to slide the tip of one finger
between your dog’s coat and one of the Probes on the Collar (see Illustration D). Separately,
you should be able to slide one finger between the strap of the Collar and the back of your
dog’s neck.
NOTE:
If your dog is going to continue to grow or grows a long winter coat, leave extra room
before trimming off the excess Strap.
Once the Collar is adjusted to the correct length, remove the Collar and trim the excess Strap
using scissors (see Illustration E). Burn the end of the Strap with a match to prevent fraying.
Illustration E
Illustration D
Fitting a Collar
Congratulations
5
6
Congratulations for completing the setup of your Radial-Shape Select
Havahart
®
Wireless Dog Fence.
You are now ready to start training your dog and enjoying your Fence.
www.HavahartWireless.com
1-800-800-1819, Option 453
!
IMPORTANT MESSAGE
Proper training of your dog is the most critical element to ensure the successful
operation of your Wireless Dog Fence. Consult the training section of the Instruction
Manual once you have set up your Wireless Dog Fence.
