61
6. Use only the correct number of round outside blades
and inside chippers as shown in the dado set’s
instruction manual. Blade/chippers must not exceed
13/16’’ total in width.
7. Check the saw to ensure that the dado will not strike
the housing, insert, or motor when in operation.
For your own safety, always replace the blade,
blade guard assembly, and table insert when you
are finished with the dado operation. You must also
realign the blade guard assembly.
Fig. NN
1
2
3
WARNING
!
Summary of Contents for X-PERT HETS-001
Page 9: ...45 UNPACKING YOUR TABLE SAW A B C D E F G H I J K L M N O P Q R S T U V W X ...
Page 30: ...66 10 JOB SITE TABLE SAW MODEL NO RETS 001 SCHEMATIC A ...
Page 32: ...68 10 JOB SIDE TABLE SAW MODEL NO RETS 001 SCHEMATIC B OP ER AT OR S M AN UA L ...
Page 34: ...70 10 JOB SITE TABLE SAW MODEL NO RETS 001 SCHEMATIC FOR STAND ...