background image

1.

Charge batteries indoors only.

2.

Keep the battery charger away from rain or 

       moisture. 

Penetration of water in the battery charger 

       increases the risk of an electric shock.

3.

Do not charge other batteries.  

The battery charger 

       is suitable only for charging 14.4 V or 18 V 

       HAUSSMANN Ni-Cd batteries. Otherwise there is 

       danger of fire and explosion. 

4.

Only charge the battery at an ambient temperature

       between 0

0

C (32

0

F) and 45

0

C (113

0

F).

A longer battery

       service life is achieved in this manner.

5.

Keep the battery charger clean. 

Contamination can 

       lead to danger of an electric shock.

6.

Before each use, check the battery charger, cable 

       and plug. If damage is detected, do not use the 

       battery. Never open the battery charger yourself. 

       Have repairs performed only by a qualified 

       technician and only using original spare parts. 

       Damaged battery chargers, cables and plugs increase

       the risk of an electric shock.

7.

Do not operate the battery charger on easily 

       inflammable surfaces (for example, paper, textiles, 

       etc.) or surroundings. 

The heating of the battery 

       charger during the charging process can pose a fire 

       hazard.

The numbering of the product features refers to the 

illustration of the tool above:

1.    Battery pack

2.    Battery charger

3.    Red light

4.    Green light

The battery is not charged when purchased and must 

be charged fully before operation. A new battery, or a 

battery that has been stored for some time, may not 

initially accept a full charge. This is normal. It will charge 

fully after several charge and discharge cycles. The first 

charge of a battery pack will take up to 1hour. Subsequent 

full charges will also take up to 1 hour. The batteries 

should be charged at an ambient air temperature of 

between 0

0

C (32

0

F) and 45

0

C (113

0

F).

To charge a 14.4 V or 18 V NiCd battery pack,proceed 

as follows:

1. Connect the charger to the mains supply and switch on. 

    The green light stays on. The red light is off.

2. When the battery pack is inserted into the charger,the 

    red light will flash(frequency=1Hz). The green light 

    stays on.

3. When the battery is fully charged,both the green and 

    red lights will remain on.

4. In the event of the failure,the red light will 

    flash (frequency>2Hz).The green light stays on.

When the battery is fully charged, please remove the 

battery pack from the battery charger. Do not leave the 

battery in the charger when the charger is plugged in.

1.  Charging the battery

2.  Remove the battery

SAFETY RULES

Read all safety warnings and all instructions.

 Failure 

to follow the warnings and instructions may result in 

electric shock, fire and/or serious injury.

KNOW YOUR PRODUCT

TECHNICAL DATA

OPERATION

Battery type

Input voltage
Output voltage
Current
Charging

temperature range

Battery model

Charging time
Protection class 

14.4V battery pack

AC120V, 60Hz

DC12-18V

1.3A

B0P-SP18-14

1 hr

18V battery pack

AC120V, 60Hz

DC12-18V

1.3A

B0P-SP17-18

1 hr

3

4

0

0

C(32

0

F) ~45

0

C(113

0

F) 0

0

C(32

0

F) ~45

0

C(113

0

F)

 (fig.1)

6

ENGLISH

Summary of Contents for HYCH0402701300U








Reviews: