A
OPERATING INSTRUCTIONS
16
OPERATION INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
1. CHARGING THE BATTERY
Chargers and batteries are specifically
designed to work together. Do not attempt to
use batteries with any other charger than that
specified in these instructions.
Important notes for charging the battery:
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
BEFORE USING YOUR CORDLESS
HEGDGE TRIMMER, YOU MUST FULLY
CHARGE THE BATTERY
Your battery pack is UNCHARGED and must
be fully charged once before use. Please note
that your battery pack will not be fully charged
until you have performed several charge and
discharge operations by charging & working
with your hedge trimmer. After this your battery
pack performance will improve.
2. INSTALL THE CHARGER STANDS (SEE
FIG.A1, A2 & A3)
Fig A1
Fig A2
Fig A3
Slide the two charger stands (A) into the both
grooves on back of the charger. The charger
can stand as shown in Fig.A3.
3. TO CHARGE THE BATTERY (SEE A4)
Fig A4
B
C
Connect the battery charger to the power
supply and the green light (B) will illuminate.
Slide the battery pack (6) into the charger to
make the connection. The green light (B) will
turn off and the red light (C) will illuminate
to show charging has started. A discharged
battery at normal room temperature will take
approximately 1 hour to reach full charge.
When charging is completed the green light
(A) will illuminate and the red light (C) will turn
off.
When battery charge runs out after
continuously use or exposure to direct
sunlight or heat, allow time for the tool to
cool down before re-charging to achieve
the full charge.
NOTE:
This charger is designed to detect some
problems that can arise with battery pack.
