11
ENGLISH
OPERATION
MAKING THE CUT
Place the cutting wheel on the rear edge of the tile. Then slide the wheel
backward by pushing the handle down with medium pressure, scoring the tile
surface glaze as the handle is pushed backward (See “SCORING” photo on the
left). It is important to make one continuous motion, scoring the surface only once
per tile. After scoring, and without moving the tile, position the handle so that the
breaker bar is slightly in from the front edge of the tile and front stop. Apply
increasing pressure on the handle until the tile snaps along the score line (See
“SNAPPING” photo on the left).
DIAGONAL CUT
The cutting guide can also assist in making diagonal cuts. First loosen the slide
rule guide knob so it can move side to side to adjust to the size of the tile you are
cutting. Then loosen the knob on the angle cutting guide to allow the tile to rest
against the angle guide, when the tile is positioned for a diagonal cut. Tighten both
knobs. You are now ready to make the diagonal cut.
ADJUSTING THE RULER
Tighten the adjustment screw to adjust the ruler at 90º with guide rail before
cutting.
HEIGHT ADJUSTMENT OF GUIDE RAIL
Note: In order to cut tiles with different thickness, adjust guide rail height by
turning the adjustment knob upward or downward within 1/8- 3/16 in (3-5 mm).
Please make sure the guide rail is parallel with the base.
Base
Ruler adjustment screw
Guide Rail
Adjustment Knob
Base
