ENGLISH
ASSEMBLY
ASSEMBLING THE ARM
1. Set the arm (1) to the middle of handle. (Fig.2)
2. Fix the long-set bracket (2) into the hole of arm. (Fig.3)
3. Put the washer (3) into the bracket and then tighten the screw nut (4). (Fig. 4)
4. Put the washer (3) into the bracket of opposite side then tighten the screw nut
(4). (Fig. 5)
5. Check that four nuts and two brackets have been tightened, and the arm is
fixed firmly.
CHANGING THE FOOT PLATE (Fig.6)
WARNING!
Disconnect the tool from the air source whenever changing the foot
plate. Make sure there is no fastener in magazine before changing the foot plate.
1. Disconnect tool from air supply.
2. Empty the magazine completely.
3. Fire the tool into a piece of scrap wood to ensure there is no compressed air
fasteners left in the tool.
4. Set the tool on its side to expose the three screws.
5. Remove the three screws, then remove the foot plate.
6. Align the three screw holes in the replacement foot plate with the three
threaded mounting holes.
7. Use the three screws previously removed to secure the replacement foot
plate to the tool.
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
Foot plate
Screws
!
21
