95
4001055180
E 06.21
USA / GB
HA26 RTJ O - HA26 RTJ O SW - HA26 RTJ PRO - HA26 RTJ PRO SW -
HA80 RTJ O - HA80 RTJ PRO
C
- Familiarization
3 - Power source - Engine specifications
3.1 -
G
ENERAL
SAFETY
AND
SPECIFIC
INTERVENTIONS
ON
MOTOR
The technician should take all steps to protect themselves or others against all risks of injury inherent
in his intervention.
The technician should ensure that suitable PPE (personal protective equipment) for the job is used, and
check the particular conditions of environment in which the material can be found (see safety
information specific to the operation site).
• Turn off the ignition, remove the key, open the battery switch before working on the engine.
• Accidental engine starting can cause injury or death to personnel working on the equipment. To avoid
accidental engine starting, disconnect the battery cable from the negative (-) battery terminal.
Completely tape all metal surfaces of the disconnected battery cable end in order to prevent contact
with other metal surfaces which could activate the engine electrical system. Place a do not operate
tag at the start/stop switch location to inform personnel that the equipment is being worked on.
• The hot engine parts can cause injury and burns. Before performing maintenance on the engine, cool
the engine and parts.
• By touching a functioning engine, there is a risk of burns from contact with hot parts, and injuries by
the rotating parts.
• To avoid any risk of accident, using compressed air (example : blowing air filter), always wear a
headband and goggles.
• The hot coolant, steam and alkalis can cause injury. At the operating temperature, the engine coolant
is hot and under pressure. Do not open the cap of the expansion chamber before letting the circuit
cool.
• The radiator and all the pipes going to the heaters or engine contain hot coolant or steam. Contact
can cause severe burns.
3.2 -
G
ENERAL
S
PECIFICATIONS
N.B.-:-U
SING
UNSUITABLE
FUEL
MAY
CAUSE
DIMINISHED
PERFORMANCE
,
DIFFICULTIES
STARTING
,
EXCESSIVE
POLLUTION
AND
PREMATURATE
WEAR
. T
O
ESTABLISHED
THE
TYPE
OF
THE
FUEL
SUITABLE
FOR
THE
ENGINE
FITTED
ON
YOUR
HAULOTTE®,
PLEASE
REFER
TO
THE
ENGINE
MANUFACTURER
'
S
MANUAL
. T
HE
ENGINE
MAY
NOT
BE
COVERED
BY
THE
WARRANTY
IN
CASE
OF
DAMAGE
CAUSED
BY
USING
UNSUITABLE
FUEL
.
The engine exhaust gases contain harmful combustion products. Always start and run the engine in a well
ventilated area. In an enclosed area, evacuate the exhaust outside.
Summary of Contents for HA26 RTJ PRO SW
