Haulotte Group HTL 3210, Operator'S Manual

Page: 219 / 248

219
2420344510 E 11.11 AUS
Telescopic handlers
H
- Lubrication and maintenance
17 - Every 2000 h hours of operation (or every 2000 h years)
17.1 - COOLING SYSTEM
• Change the coolant :
Capacity : approx. 18 l(4,75 gal US).
N.B. -:-Open the heating valve situated in the cab when draining the cooling system.
• Remove the filter cap from the expansion bottle filter cap.
• Loosen the drain plug and let the coolant drain out.
• Empty the expansion bottle.
• Clean the system thoroughly with water (or, if necessary, with a cleaning product). In this case,
retighten the plug and let the engine run at mid throttle for 10 mn, stop the engine and drain the system
again.
• Refit the drain plug.
• Filling the cooling system :
• Remove the filter cap from the expansion bottle filter cap.
• Fill the radiator GRADUALLY until the coolant has reached the correct level.
• Close the expansion bottle cap again.
• Switch the acceleration control lever to IDLING.
• Start the engine.
• Let the engine run AT IDLING SPEED for approx. 2 mn.
• Stop the engine.
• Open the expansion bottle and top up if necessary.
17.2 - AIR FILTER (SYSTEM)
Change the filter cartridge :
• Remove the cover :
• Pull the trigger situated on the cover ( Section H 7.5 Marking1).
• Locate and note the angular position of the cover which should be identical upon reassembly.
• Turn the cover to the right ( Section H 7.5 Marking2).
• Pull the cover to remove it.
• Turn and pull the (primary) outer cartridge. Then pull the (secondary) inner cartridge
( Section H 7.5 Marking3).
• Insert a new secondary cartridge, by pushing it to the bottom of the socket provided in the case.
Before performing any interventions, let the engine cool down.
Never clean the cartridge by hitting it against a hard surface or by using hot flammable liquid.