Page 6
For technical questions, please call 1-888-866-5797.
Item 92626
Installation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note:
For additional information regarding the parts listed in the following pages, refer to
Parts List and
Assembly Diagram
on page 10.
Mounting
This Trailer Jack is designed
specifically for use with
an A-frame hitch.
Never attempt to mount this Trailer
Jack to a hitch or trailer not specifically designed for it.
An example of an A-frame hitch is shown in Figure A.
Check that the Outer Tube (1) of the Jack will fit into
the A-frame opening and that the Mounting Plate
holes align with the bolt locations on the trailer. Only a
qualified technician should modify the trailer if needed.
1. Block the wheels and support the trailer A-Frame
securely using jack stands (sold separately).
2. Insert the top of the Trailer Jack up through
the hole in the center of the A-frame hitch
from underneath until the top of the Mounting
Plate rests against the underside of the
hitch. Line up the holes on the Mounting Plate
with the bolt holes in the A-frame hitch.
3. Secure the Mounting Plate to the A-frame using
lock nuts, bolts and washers (all sold separately)
as listed under Hardware in the Specifications chart
on page 4. Slide a washer onto each bolt, then
insert them from the top side and attach a washer
and lock nut from the underside of the frame.
Tighten mounting hardware firmly to 15 – 20 ft. lb.
Use a torque wrench to confirm tightness.
Note:
As an alternative, the Mounting Plate may be
welded into place on the underside of the A-frame
hitch by a certified welder. Welds must be properly
cleaned and painted when cool to prevent corrosion.
4. Insert the Foot Plate (11) over the bottom of
the Inner Tube (2). Insert the Lock Pin (12)
to secure the Foot Plate in place. Use the
spring clip on the Lock Pin to secure it.
Align bolt
holes
Insert Jack into A-frame opening
Figure A
5. Once the Jack is mounted to the trailer
tongue, attach the Crank (10) to the Jack
Screw (9) at the top of the Trailer Jack. Secure
Crank in place with the Bolt (7) and Lock
Nut (8). Securely tighten all hardware.
SAFETY
OPERA
TION
MAINTENANCE
INST
ALLA
TION
Summary of Contents for 2000 LB. A-Frame Trailer Jack
Page 1: ......
