Haug EN SL MT Series, Operating Instructions Manual

Page: 10 / 20

Installation
Page 10
4.2 Setting up, connecting
_____________________________________________________________________________________
WARNING!
High voltage!
Danger of fatal accidents!
Do not open unit!
WARNING!
Only plug in/unplug coaxial connector when the unit is switched off!
_____________________________________________________________________________________
1. Before connecting always check that the unit is suitable for the local mains
voltage (the voltage is indicated on the name plate). Incorrect mains voltage
may result in damage to the unit.
2. Set up unit at the required site of usage (if required, attach using the enclosed
holders).
3. Ensure that the unit is switched off (for mains switch, refer to Figure 1, item 1,
page 8).
4. Connect ionizing units to high-voltage terminals.
5. Always connect unit to a socket with functioning ground wire. Always use the
supplied mains cable with its integrated ground wire.
6. Put unit into operation.