Hatteland HD 08T21 STD-xxx-F Series, User Manual

Page: 15 / 40

15
INB100535-2 (Rev 1)
IND100078-29
General Installation Recommendations
Installation
Configuring housing connectors
Housing connectors are available in different sizes (2-pin, 4-pin, 5-pin) which plugs into the connector area of the unit.
These housing connectors are by factory default mounted on the unit. Below is a brief illustration that might be useful
during configuration and installation of such connectors. You will need suitable pre-configured cable(s) and tools to
configure the connector(s) and cable(s) that are present in your installation environment. Below is a sample for a 2-pin
DC power connector. The procedure is the same for other connectors of this type.
FIG 1
FIG 3
FIG 2
FIG 4
FIG 1: Unscrew (from top) or make sure that the screw terminal (square area) are fully open, so you can secure the
inserted cables correctly to the loose housing connector (it may already be plugged into the unit as per factory
installation).
FIG 2: Insert cables* (from front) and screw / secure the cables by turning the screw on top of the housing to secure
the cables properly. Check that the cables is firmly in place and do not appear loose or falls out when pulling gently.
*Note: Required polarization verification (for instance -/+ for DC power input) should conform with the markings on
the connector area of the unit. Ignoring the markings on the unit or its add-on modules might damage the unit and/or
external equipment in which end, warranty will be void.
FIG 3: Plug the housing into the appropriate connector area of the unit and check again that the cables secured
conforms with the markings on the connector area of the unit. Finalize the installation by fasten the screws located in
front on each side of the housing connector (FIG 4).