Form No. TPTM-0910
5
INSTALLATION
General
The Pop-Up Toaster is shipped with all components pre-
assembled. Care should be taken when unpacking the shipping
carton to avoid damage to the unit and the components enclosed.
ELECTRIC SHOCK HAzARD: Unit is not weatherproof.
Locate the unit indoors where the ambient air temperature
is a minimum of 70°F (21°C).
ExPLOSION HAzARD: Do not store or use gasoline or
other flammable vapors or liquids in the vicinity of this or
any other appliance.
FIRE HAzARD:
• Locate unit a minimum of 1″ (25 mm) from combustible
walls and materials. If safe distances are not
maintained, combustion or discoloration could occur.
• Do not place anything on top of toaster. Do not place
toaster near or underneath curtains or other combustible
materials. Items near or on top of the toaster could catch
fire causing injury and/or damage to the toaster.
NOTE: The TPT-120 Toaster draws 15 amps and requires its
own circuit.
WARNING
1. Remove the unit from the carton.
2. Remove the information packet.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
3. Remove tape and protective packaging from all surfaces of
the unit.
4. Place the unit in the desired location.
• locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F (21°C).
Avoid areas that may be subject to active air movements
or currents (i.e., near exhaust fans/hoods and air
conditioning ducts).
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• Make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
OPERATION
General
The Pop-Up Toaster is designed for ease of operation. Perform
the following procedure to operate the toaster.
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICATIONS section for details.
NOTE: The TPT-120 is equipped with cord wrap clips on the
bottom of the toaster to minimize clutter. Place excess
cord around cord wrap clips.
Figure 4. TPT-120 Cord Wrap Clips
2. Set the COlOR CONTROl knob(s) to
the desired toast darkness setting. The
“1” setting on the COlOR CONTROl
knobs represents the lightest toast
setting and the “7” setting represents
the darkest.
3. Place bread product in toasting slot(s).
WARNING
Cord Wrap
Clip
4. Push down on the operating lever(s) to lower product into
the toaster.
• As soon as the operating lever is pushed down, the
heating elements inside the toaster energize and begin
heating.
BURN HAzARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
• When the toasting cycle is complete, the timer bell rings,
the heating elements shut off, and the operating lever(s)
rises automatically.
NOTE: The operating lever(s) can be lifted manually during
toasting for product removal.
ELECTRIC SHOCK HAzARD:
• Unplug power cord and allow unit to cool before
performing maintenance, cleaning, or attempting to clear
a jam.
• NEvER insert a knife, fork, or similar object into toasting
chamber.
5. Remove and empty the crumb tray periodically in between
toasting cycles.
Always operate toaster with crumb tray installed.
The toasting of coated or buttered products such as garlic
bread, cheese sandwiches, and sweet rolls is NOT
recommended. Residue will reduce toaster performance and
could ignite inside the toaster. Using the toaster with the food
products listed above will void the unit warranty.
CAUTION
WARNING
CAUTION
