MAINTENANCE
English
8
Form No. mVWm-0515
General
mini Vertical Warmers are designed for maximum durability and
performance, with minimum maintenance.
ELECTRIC SHOCK HAzARD:
• Turn OFF power switch, unplug power cord, and allow
unit to cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not clean unit when it is energized or hot.
• Do not steam clean or use excessive water on unit.
• This unit is not “jet-proof” construction. Do not use jet-
clean spray to clean this unit.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
This unit has no “user-serviceable” parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350; fax 800-690-2966; or
International fax 414-671-3976.
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
WARNING
NOTICE
Daily Cleaning
To preserve the finish of the mini Vertical Warmer, perform the
following cleaning procedure daily.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
IMPORTANT—DO NOT use paper towel or glass cleaner to
clean plastic surfaces. Paper towel and glass cleaner may
scratch the material. Wipe off plastic surfaces using a soft,
clean, water-dampened cloth.
1. move the Power I/O Switch (on/off) to the O (off) position,
unplug the power cord, and allow the unit to cool.
2. Remove all unused product and the dispensing insert, if
installed.
3. Wipe down all metal and composite surfaces with a water-
dampened, non-abrasive cloth.
4. Clean the plastic flip-up door using soft cleaning cloths, mild
soap, and water.
NOTICE
: Do not use paper towel or
glass cleaner on plastic surfaces—scratching may
occur.
5. Wipe dry the entire unit using a non-abrasive, dry cloth.
NOTICE
