![background image](http://html.mh-extra.com/html/hatco/mdw-series/mdw-series_installation-and-operating-manual_2106922012.webp)
Form No. MDWCEM-0411
12
OPTIONS AND ACCESSORIES
hood with Backlit Sign Cutout
an optional hood with a backlit sign cutout is available for all
models. The hood and sign can be rotated to face any side of
the unit.
Installing a Graphic Image
Use the following procedure to apply a graphic image to the
graphic panel for placement in the hood of the unit.
1. Disconnect the power supply and allow the unit to cool.
2. Unscrew and remove the threaded cap from the hood.
3. Remove the hood.
4. Remove the graphic panel from the hood frame.
5. apply the graphic image:
• If the graphic image is a decal, peel off the backing
paper from the graphic decal and apply the decal to the
graphic panel.
• If the graphic image is non-adhesive, trim the image to
the shape of the graphic panel leaving no more than an
3 mm (1/8″) gap between the image and the edge of the
panel. Then, tape the image to the inside face of the
graphic panel. Make sure to tape around the entire edge
of the image so that it does not hang loose.
6. Install the graphic panel with the tabs on the panel resting
in the corner notches of the hood frame.
7. Securely place the hood back onto the cabinet. Make sure
the cutout in the hood is over the graphic panel.
8. Reinstall the threaded cap to secure the hood to the unit.
Relocating the Graphic Panel
Use the following procedure to change the location of the backlit
sign on the unit.
1. Disconnect the power supply and allow the unit to cool.
2. Unscrew and remove the threaded cap from the hood.
3. Remove the hood.
4. Remove the graphic panel from its existing location in the
hood frame.
5. Remove the hood filler panel from the side where the
graphic panel needs to be installed. (Two screws need to
be removed to remove the hood filler panel.)
6. Install the hood filler panel onto the side where the graphic
panel was originally located. Make sure the top lip of the
hood filler panel fits over the edge of the hood frame and
the two screws are installed.
7. Install the graphic panel into the new position with the tabs
on the graphic panel resting in the corner notches of the
hood frame.
8. Securely place the hood back onto the cabinet. Make sure
the cutout in the hood is over the graphic panel.
9. Reinstall the threaded cap to secure the hood.
Graphic Panel
Graphic Image
Tab
Threaded Cap
Hood
Frame
Hood Filler Panel
Corner
Notch
Hood with
Backlit Sign Cutout
Figure 10. Merchandising Display Sign
Summary of Contents for MDW Series
Page 74: ...Form No MDWCEM 0411 74 NOTES ...
Page 75: ...Form No MDWCEM 0411 75 NOTES ...