Form No. IR1CEM-0910
9
MAINTENANCE
General
Hatco Induction Ranges are designed for maximum durability
and performance with minimum maintenance.
ELECTRIC ShOCK hAzARD:
• Turn power OFF, unplug power cord, and allow unit to
cool before performing any maintenance or cleaning.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on the unit.
• This unit is not “jet-proof” construction. Do not use jet-
clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
This unit has no “user-serviceable” parts. If service is
required on this unit, contact an Authorized hatco Service
Agent or contact the hatco Service Department at
414-671-6350; fax 414-671-3976.
Wipe up all spills and splashes immediately. Make sure unit
is dry before using. Do not allow liquid to run into air inlet
filter on bottom of unit.
Daily Cleaning
To maintain performance and preserve the finish of the
Induction Range, clean the unit daily. Make sure to use only
wipes, pads, and cleaners designed specifically for cleaning
ceramic glass surfaces.
1. Turn off the unit and allow to cool.
2. Remove and wash all food pans.
3. Clean the glass surface using an appropriate cleaning
wipe, damp paper towel, or damp cloth.
• For tough stains and metal marks, use a drop of ceramic
glass cleaner and paper towel.
• For water and scale marks, use a few drops of white
vinegar and paper towel.
Use non-abrasive cleaners only. Abrasive cleaners could
scratch the finish of the unit, marring its appearance and
making it susceptible to soil accumulation.
4. Clean the metal surfaces using a clean, soft cloth and mild
detergent.
WARNING
CAUTION
NOTICE
Cleaning the Air Inlet Filter
The air inlet filter on the bottom of the unit should be removed
and cleaned monthly. Use the following procedure to clean the
filter.
1. Turn off and unplug the unit .Allow the unit to cool.
2. Access the air inlet filter.
• For counter top units, turn the unit upside down and lay
the unit on a soft, non-scratching surface.
• For built-in units, access the bottom of the unit.
3. Remove the frame screw on the filter frame.
4. Lift the filter frame and air inlet filter off of the unit.
5. Clean the air inlet filter with soapy water.
6. Allow the air inlet filter to dry completely.
7. Place the air inlet filter inside the filter frame and install onto
the bottom of the unit.
• Insert the tabs on the filter frame into the tab slots on the
bottom of the unit.
8. Insert the frame screw and tighten securely.
9. For countertop units, return the unit to the upright position.
Figure 12. Removing the Air Inlet Filter (Model IR1-3000 shown)
Frame
Screw
Air Inlet
Filter
Tab
Filter Frame
Tab Slot
