![background image](http://html.mh-extra.com/html/hatco/hdw-1/hdw-1_installation-and-operating-manual_2106893011.webp)
Form No. HDWM-0214
11
INSTALLATION
English
General
Hatco Drawer Warmers are shipped with most components pre-
assembled. Care should be taken when unpacking the shipping
carton to avoid damage to the unit and components enclosed.
ELECTRIC SHOCK HAzARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 70°F (21°C).
FIRE HAzARD: Locate unit a minimum of 1″ (25 mm) from
combustible walls and materials. If safe distances are not
maintained, combustion or discoloration could occur.
Do not lay unit on the front or back side. Damage to the
unit could occur.
1. Remove the unit from the carton.
2. Remove the information packet from the drawer of the unit.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTaNT OWNER INFORMaTION
section for
details.
3. Remove tape and protective packaging from all surfaces of
unit.
4. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F (21°C).
avoid areas that may be subject to active air movements
or currents (i.e., near exhaust fans/hoods and air
conditioning ducts).
• Make sure the unit is located on solid, level flooring or in
sturdy cabinetry.
• Make sure the unit is at the proper height in an area
convenient for use.
5. Install the unit. Refer to the appropriate installation
procedure in this section.
NOTICE
WARNING
Installing HDW-X and HDW-XN Models
HDW-X and HDW-XN models are freestanding units that require
the installation of 4″ (102 mm) legs or casters before operation.
1. Remove the plastic bag containing the four legs or casters
from the drawer of the unit.
2. Carefully lay the unit on its side (requires two people).
3. Install each leg or caster. Refer to the appropriate
procedure in this section.
4. Return the unit to its upright position (requires two people).
For units on legs — If the unit is not level or rocks, turn the
adjustable tip of the appropriate leg to level the unit.
Installing Legs
1. Thread a leg into the hole located at one corner of the unit.
2. Hand-tighten the leg until snug. Do not over-tighten.
3. Repeat steps 1 and 2 for the remaining three legs.
Leg Installation on HDW-2 Model
Installing Casters
1. align the four holes on the caster plate with the four holes
in the bottom of the unit at one corner of the unit.
2. Install a bolt through each of the holes in the caster plate
and into the bottom of the unit. Tighten securely.
3. Repeat steps 1 and 2 for the remaining three casters.
Caster Installation on HDW-3 Model
Caster
Plate
Bolt
Lengthen
Shorten
Adjustable
Tip