Form No. FSHC67M-0808
6
INSTALLATION
ALL MODELS
The Flav-R-Savor
®
Portable Holding Cabinets are
shipped with most components installed and ready
for operation. The following installation instructions
must be performed before plugging in and operating
the cabinet.
1. Remove unit from box.
2. Remove information packet.
To prevent delay
in obtaining warranty coverage, fill out and
mail in the warranty card
.
3. Remove tape and protective packaging from all
surfaces of unit. Remove Rack Slide Assembly.
4. Install the handle(s) to the access door(s).
(See Figure 4.)
NOTE: On FSHC-6W series, install handle using the
two upper most mounting holes.
5. Carefully lay the unit on its side. Thread one leg
or mount caster using hardware provided onto
the cabinet bottom and tighten securely.
(See Figure 4.) Return cabinet to the upright
position.
NOTE: Place a piece of cardboard between the
cabinet and floor to prevent marring the cabinet
finish.
6. Unpack the adjustable steel rack slides from the
carton, and install them to the rack as shown in
Figure 4. Make sure the bottom shoe of each
rack faces outward.
NOTE: If installing the optional Stacking Kit, see
ACCESSORIES
for installation instructions.
Reservoir Drain Tube
Steel Rack (Qty. 2)
Handle
Adjustable Rack Slide
Glass Door Shown
(Heavy Duty Stainless Steel
Door Optional)
4" (102 mm)
Heavy Duty Caster
(Standard)
2" (51 mm)
Low Profile Caster
(Optional)
4" (102 mm) Adjustable Leg
(FSHC-7 Series Only)
(Optional)
6" (152 mm) Adjustable Leg
FSHC-7 Series Only
(Optional)
Reversible Access Door
(FSHC-6W-2 & FSHC-7-2
equipped with front and
rear doors)
Figure 4. FSHC -6W & -7 Series
Summary of Contents for FLAV-R-SAVOR FSHC-6W1
Page 18: ...Form No FSHC67M 0808 16 NOTES ...
Page 19: ...Form No FSHC67M 0808 17 NOTES ...
