MAINTENANCE
Form No. GRSDSDBKM-0407
6
CLEANING
The Sandwich Display Warmer is designed for
maximum durability and performance, with minimum
maintenance.
WARNING
To avoid any injury, turn the power switch OFF
unplug the unit from the power source and allow
to cool completely before performing any
maintenance and cleaning.
WARNING
Units are not waterproof. DO NOT submerge in
water. Do not operate if unit has been
submerged in water.
To preserve the bright finish of the Display Warmer,
it is recommended that the exterior and interior
surfaces be wiped daily with a damp cloth. Stubborn
stains may be removed with a good stainless steel
cleaner or a non-abrasive cleaner. Hard-to-reach
areas should be cleaned with a small brush and mild
soap.
WARNING
To avoid electrical shock or personal injury, do
not steam clean or use excessive water on the
unit.
NOTICE
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit
cabinet marring its appearance and making it
susceptible to soil accumulation.
DISPLAY LIGHT BULB REPLACEMENT
The display light is an incandescent light bulb which
illuminates the warming area. The bulb has a
special coating to guard against injury and food
contamination in the event of breakage.
1. To replace a light bulb, disconnect the power
supply and wait until the unit has cooled.
2. Light bulbs have a threaded base. Unscrew the
light bulb from the unit and replace it with a new
specially-coated incandescent light bulb.
Note: Hatco shatter-resistant light bulbs meet NSF
standards for food holding and display areas. For
120, 120/208 and 120/240 volt applications, use
Hatco part number
. For 220 or 240
volt applications, use Hatco part number
WARNING
Only light bulbs which meet or exceed NSF
standards, specifically designed for food
holding areas may be used. Breakage of light
bulbs not specially coated could result in
personal injury and/or food contamination.
WARNING
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
WARNING
This product has no “user” serviceable parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Parts when service is required.
WARNING
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.
Summary of Contents for Burger King Glo-Ray GRSDS Series
Page 14: ...Form No GRSDSDBKM 0407 12 NOTES...
