HOW TO REPLACE THE REMOTE CONTROL BATTERY
CARE AND CLEANING INSTRUCTIONS
Signal Emitter
Lock
Open the battery cover by using your fingernail to push the catch downwards as shown by the arrow
and remove the battery cover. Replace the used batteries with new “AAA” batteries, ensuring that
the positive (+) and negative (-) poles are correctly inserted and correspond with the symbols on
the remote control. Placethe battery cover back in its original position.
*Batteries should be removed from the remote control when not in use for a long period of time.
1.
2.
3.
4.
Use a damp cloth to wipe stains, and then dry the area by wiping.
When cleaning the fan, be careful not to let the wire, switch, motor and other electrical components get wet.
Do not use chemical products, thinner solvents, alcohol, kerosene or petrol to clean the fan.
The water tank, pre-filter, grilles, and water tank can be cleaned with water or soapy water. It should be cleaned at least
every 1-2 months.
How to remove the pre-filter (back)
Use a screwdriver to loosen the screws and press
the locks located at the top with your hands (left-right)
to remove the pre-filter for cleaning.
PRE-FILTER
How to place the pre-filter within the side grilles
Flip the side grilles upward and place the pre-filter
in place within the frame boundary (A) ensuring that
the side with the arrow is at the top.
SIDE GRILLES
PRE-
FILTER
B
A
B
PRE-FILTER
A
SIDE GRILLES
How to remove the pre-filter (side)
Use your hands to press the locks located at the top
to unlock it. Lift the grilles upwards to free it from
the latches in the middle and remove the pre-filter
for cleaning.
SIDE GUARDS
PRE-FILTER
Replace
Remove
6
