• Remove the magazine slide completely
• Load a new film
• Wind the camera
• Complete the camera release and
rewind the camera
• Remove the lens cap
• Complete the camera release and
rewind the camera
• Wind the lens
• Complete the camera release and
rewind the camera
• Complete the camera release and
rewind the camera
• Push the magazine slide until it posi-
tively stops
Troubleshooting
P
ROBLEM
R
EMEDY
• The magazine slide is still in place
• The film is finished
• The camera is not rewound
• The camera is in the pre-released or
released position
• The lens cap is still in place
• The camera is in the pre-released or
released position
• The lens is in the released position
• The camera body is in the pre-released
or released position
• The camera body is in the pre-released
or released position
• The magazine slide is not fully inserted
P
OSSIBLE
CAUSE
You cannot operate the
exposure release button
There is no image on the
focusing screen
You cannot remove the front
protective cover
You cannot attach the lens
You cannot remove the lens
You cannot remove the
magazine
Your camera is built to give long and trouble-free service, especially when you follow the maintenance
and care advice at the end of this manual. If however you encounter any operating difficulties because
you are not familiar with the Hasselblad camera system, the following table may help to resolve them.
If the problem persists and the camera is still under guarantee, you should contact your Hasselblad
dealer. If the guarantee has expired, you should contact a Hasselblad Authorised Service Center for
advice. You can obtain the address of your nearest service centre from your dealer, distributor, our
23