1
1
2
3
4
4
5
5
2
3
STOP! Do you have a Barge Buddy? We recommend assembling Jabba’s Sail Barge with
a friend. It’s precious cargo, and the perfect assembly is all about finding a balance.
UNPACKING
NOTE: DO NOT HOLD BARGE BY RAILINGS.
The main portion of the ship is packed out as
one piece. Additional pieces are stored in the
accessory box beneath.
To protect the barge, prepare a soft surface like a
bed, a blanket on the floor, or a tauntaun carpet.
Remove Jabba the Hutt
TM
figure and Yak Face
TM
figure/card from foam end pieces and set aside (1).
Remove center foam brace (2).
Slide accessory box out from below barge and
set aside (3).
Tear plastic bag down middle along perforation
and slide plastic away from center (4).
Carefully hold barge from underneath while gently
removing plastic and end foam pieces, one at a
time (5).
With the help of your Barge Buddy, carefully place
the barge onto the soft surface you’ve prepared.
Gently roll the barge away from you onto its side
to begin assembly.
Find fins and side antennae in the
accessory box.
Snap keyed portside and starboard
antennae into place as shown (1).
Slide portside and starboard fins behind side
mounts and snap pins into place, making sure
that pin marks are facing inwards toward ship (2).
NOTE: Fins are intended to pivot slightly.
SUPPORT FEET, FRONT ANTENNA
AND ENGINE DETAILS
FINS AND SIDE ANTENNAE
ASSEMBLY
Find support feet, antenna, and engine details in the
the accessory box.
Attach support feet. Support feet MUST be attached
prior to attaching fins.
For additional support, keep one hand on the deck
of the Barge while attaching feet. Snap each keyed
foot into place. NOTE: Feet are removable for
storage purposes.
Press bottom antenna into place as shown (1).
Press engine details into place as shown (2).
2
1
2
1
E25962040_359543_SW_E6_HASLAB_JABBAS_SAIL_BARGE_KHETANNA_INST.indd 2-3
9/13/18 5:09 PM
