13
Manual Mode
After pushing the MANUAL MODE key in the Main Menu screen, the following screen will appear:
1. Push the START/STOP key to pause the system while in operation.
2. Push the OVERRIDE key to turn on all three pumps at the same time for full output of the system. Use
this mode when going through a short area of wet crop.
3. In Manual Mode you can turn the pumps on or off by pressing the underlined area next to the pump
numbers. In Manual Mode (regardless of moisture, baling rate or bale weight) the outputs of the pumps
are fixed rates as follows:
Round Balers
Pump
Low Tips Output
(Lbs / HR)
High Tips Output
(Lbs / HR)
1
45
75
2
90
140
3
135
265
Small Square Balers
Pump
Low Tips Output
(Lbs / HR)
High Tips Output
(Lbs / HR)
1
25
40
2
75
75
3
145
205
4. The moisture content is shown in the upper right hand corner.
5. Baling rate and Application rate are shown in the middle. The output of a pump can be checked by
dividing the preset output (shown in step 3) by the displayed baling rate.
6. Volume used shown at the bottom of the screen will show accumulated pounds of preservative used on
the go. This number will reset at power down, but remains in the job record screen.
NOTE: Initial start-
up requires pressing the New Job key in the Job Records screen in order for Volume Used
accumulation to be recorded
.
This only needs to be done once on initial start-up of system and
not every time the system is started for operation.
(See JOB RECORDS screen)
7. The baling rate is set in the SETUP MODE menu.
8. This graph shows the moisture trend from the last 90 seconds of baling (one reading every 3 seconds).
9. This button is your contrast control. Press this button to darken the screen. When the screen reaches
its darkest point, when the button is next depressed it will return to lightest setting.
10. Press the MAIN MENU key to return to the opening screen.
5.8
10
4
5
6
3
7
8
9
2
1
