System Set Up and Initial Test
1. Unpack the contents of the shipping box.
2. Check for obvious signs of exterior damage. If damage is noted,
contact BTX Technical Support before proceeding.
3. Place the Waveform Generator on the top of a sturdy table.
4. Connect the High Voltage Output Cable, Chamber Base Cable, or
Safety Stand Cable into the HV Output and Interlock Connectors
at the bottom right of the front panel.
5. Connect the mains/power cord into the Generator back panel at
the bottom right.
6. Connect the Power Cord to the mains.
7. Turn the rocker switch on the front panel to the “on” position
(I). The rocker switch Power, should illuminate and the opening
touchscreen should appear within 10 seconds. When the
instrument is fully initialized, the Log On screen display (below)
will appear.
User Identification Input
AgilePulse™ PLUS is factory configured with the system administrator
“admin” account. By default no password is defined so the user can
enter the system with parameters matching that of the initial Log On
screen. The admin password may be changed by navigating from the
Welcome screen to the User Account Maintenance screen by tapping
Setup then User.
The system administrator may add/remove pulse waveform protocols,
add/remove standard user accounts, and assign pulse waveform
protocol access privileges to standard users. The administrator always
operates under the “admin” account.
To enter user names and passwords, touch the Change buttons to
activate a virtual keyboard.
User name: Enter the user’s name to log in.
Password: Enter the password associated with the user account.
Touch OK to log in and proceed to the Welcome screen.
Welcome Screen
Log On Screen
Download full user's manual at:
www.btxonline.com
BTX AgilePulse PLUS Quick Start Guide • www.btxonline.com
AgilePulse
™
PLUS
Bipolar Transfection
System
Quick Start Guide
