66
LH5210 and LH5410 Rear Panel
1. AC Voltage selection switch
– This switch is used to set the LH Series operation voltage. Be sure to check that the
switch is set correctly for your country.
2. EFFECTS SEND jack
- Use this 1/4” unbalanced jack to send low impedance (100 ohm) signals from the LH series
amplifier to a professional outboard effects processor such as a reverb, echo, chorus, flanger, or harmonizer device.
Output level is approximately 0 dB to +4 dB and is post-EQ and post-Limiter. You can also use the Effect Send jack to
route signal to an external mixing console or amplifier with an input sensitivity of +4 dB.
3. EFFECTS RETURN jack
- Use this 1/4” unbalanced jack to return low impedance (600 ohm) signals from a professional
outboard effects processor to the LH Series amplifier.
4. Fan
- The fan provides vital cooling to your LH series combo. Make sure that it is kept free of all obstructions and
that cool, fresh air is accessible at all times. Also, try to ensure that the LH5210 or LH5410 is used in a dust-free
environment.
5. SPEAKER OUTPUT (LH5210 only)
- Connect any 8 or 16 ohm bass cabinet to this standard unbalanced 1/4” jack.
6. AC inlet
- Connect the supplied standard 3-pin “IEC” plug here.
7. Fuse sled
- This contains a fuse holder for your LH Series combo. Make sure the voltage rating is correctly set before
powering up the amplifier! Fuse ratings are 10 amp for 115 vac and 5 amp for 230 vac, both are slow blow type.
2
1
3
7
4
5
6
