MACH
®
C750-C1050 Outdoor Boilers
9
2.7 H
OOD
S
UPPORT
1. When working on the back section of the boiler the hood can be raised and supported by the
hinged top section of the boiler. This is similar to the hood of a car and prop-rod support.
2. Remove the 2 rear quick release pins only.
3. Remove the screws holding the rear top hinged section of the boiler.
4. Raise the hood until the top section can be raised and placed behind the angle supports, slowly
lower the hood until it is supported by the top section.
For further instructions on installation see MACH
®
C750-C1050 Installation
& Owner’s Manual.
Be sure to correctly support the hood using the hinged boiler cover as a
prop engaging the angle supports inside the hood. Failure to do this could result in the hood falling and
may cause severe injury or death.
Remove the 2 rear quick release
pins only! Set hinged top section
behind “L” brackets on the hood
and slowly lower hood until it is
supported by the top section.
