BAR-003, BAR-004, BAR-005
INS003
Revision 0
Code:
Product:
1
Using scissors (Do not use a knife), remove all the packaging and Identify the parts using the Pack Contents and Fig.
1 overleaf.
2
Place the upright (1) into the socket, ensuring it inserts fully.
1
4
Loosen the grub screws in the short tee clamps (8) and place over either end of a bottom bar (7). Slide the bottom rail
and two short tees over two uprights to the desired height or, if using advertisement boards, to the height shown
overleaf on page 1. Once in place slide over the Double Eyeclamps (4) and position, again, as required or to the
afformentioned dimensions.
6
Slide the elbow clamp over the upright, ensuring the handrail sits on top of the upright inside the clamp. Tighten the
grub screw that holds the hand rail in place. Other configurations (BAR-004/BAR-005) can be inserted to
lengthen/corner the barrier system. Once all the handrails are in place, tighten all the lower grub screws, fixing the
uprights to the clamps.
Insert other
barrier
configurations
Fig. 2
4
2
6
8
1
2
5
Again, using an 8mm allen key, loosen the grub screws in the elbow clamp (3). Slide 2 One Eyeclamps ove the
handrail (2) and lightly tighten as in step 3. Place the elbow clamp on the end of the hand rail (2) as shown in Fig. 2.
2
9
3
Using an 8mm allen key, loosen the grub screws in the 2 One Eyeclamps (9) and slide over a bottom rail (7), lightly
tighten to holes in place while assembling the rest of the system.
7
Repeat step 3 and 4 for the bottom rail, hand rail and double eyeclamp.
8
Place the Long Tee Clamp onto the upright, as shown in Fig. 3, ensuring the hand rail sits on top of the upright.
When adding another section to the system, ensure the next hand rail meets with the previous one to keep equal
spacing.
4
1
2
Fig. 3
Internal View of
Hand rail/Upright
7
9
2
7
4
1
2
1
11
7
12
1
Advertisement Board Mount Assembly:
Spectator Barrier System and Advertisement Mounts
(Optional)
