Harris RF-7800W-OU49 series, Installation & Operation Manual

Page: 36 / 87

3-5
RF-7800W
SYSTEM ADMINISTRATION AND CONFIGURATION
R
3.5 NETWORK INTERFACE
The radio hosts a number of management interfaces that can be accessed via IP. This section describes the
information and configuration options available for basic network configuration. See
Figure 3-4 .
3.5.1 Ethernet Port
The subsections below describe Ethernet Port configuration parameters. All parameters for Ethernet Port can be
accessed using GUI, CLI, and SNMP interfaces.
3.5.1.1 MAC Address
This is the unique Media Access Control (MAC) address of the Ethernet port. It is set by the factory and not user-
configurable. This address is used when setting up the wireless interface.
3.5.1.2 Port Mode
The Ethernet port can be configured to automatically detect the port settings based on the capabilities of the attached
device, or fixed to a particular port speed and duplex setting. Note that the port speed and duplex settings must be
compatible with the attached device, or communication could be disrupted.
3.5.1.3 Current Port Speed
When the radio is set to automatically detect the Ethernet port settings, this is the port speed and duplex setting that
is detected and in use.
3.5.2 Statistics
The radio logs the number of Ethernet data packets that have been transmitted and received. The radio also provides
the number of packets that are received with errors, which could indicate problems with the port speed or duplex
settings.
Figure 3-3. General Information
GUI CLI SNMP