Chapter 3
Operation
18
Copyright © 2003, 2005-2006, 2010, Harris Corporation
Remote Control
When the jumper is set to the “remote” position, the reclocker setting is handled
by
+
Pilot Lite only. You may select the three setting modes (automatic, manual,
and bypass) remotely via
+
Pilot Lite.
ASI
(see
Figure 3-1
on page 16 for a picture of the jumper
set settings)
Set the jumper on the pin that allows the reclocker to
handle ASI data only
If the reclocking is successful, the RCLK LED will be
green and the 270 Mb/s LED will be yellow
If the reclocking is not successful, the RCLK LED will
be red, the 270 Mb/s LED will be off, and
un-reclocked data will be present at output
Table 3-1
Reclocking Mode Setting
(Continued)
Input Signal
Operation Setup
