HSD/HSE6800
+
Installation and Operation Manual
17
Copyright © 2003, 2005-2006, 2010, Harris Corporation
Table 3-1
Reclocking Mode Setting
Input Signal
Operation Setup
143 Mb/s
(see
Figure 3-1
on page 16 for a picture of the jumper
set settings)
Set the jumper on the pin that allows the reclocker to
handle 143 Mb/s data only
If the reclocking is successful, the RCLK LED will be
green and the 143 Mb/s LED will be yellow
If the reclocking is not successful, the RCLK LED will
be red, the 143 Mb/s LED will be off, and
un-reclocked data will be present at output
177 Mb/s
(see
Figure 3-1
on page 16 for a picture of the jumper
set settings)
Set the jumper on the pin that allows the reclocker to
handle 177 Mb/s data only
If the reclocking is successful, the RCLK LED will be
green and the 177 Mb/s LED will be yellow
If the reclocking is not successful, the RCLK LED will
be red, the 177 Mb/s LED will be off, and
un-reclocked data will be present at output
270 Mb/s
(see
Figure 3-1
on page 16 for a picture of the jumper
set settings)
Set the jumper on the pin that allows the reclocker to
handle 270 Mb/s data only
If the reclocking is successful, the RCLK LED will be
green and the 270 Mb/s LED will be yellow
If the reclocking is not successful, the RCLK LED will
be red, the 270 Mb/s LED will be off, and
un-reclocked data will be present at output
360 Mb/s
(see
Figure 3-1
on page 16 for a picture of the jumper
set settings)
Set the jumper on the pin that allows the reclocker to
handle 360 Mb/s data only
If the reclocking is successful, the RCLK LED will be
green and the 360 Mb/s LED will be yellow
If the reclocking is not successful, the RCLK LED will
be red, the 360 Mb/s LED will be off, and
un-reclocked data will be present at output
540 Mb/s
(see
Figure 3-1
on page 16 for a picture of the jumper
set settings)
Set the jumper on the pin that allows the reclocker to
handle 540 Mb/s data only
If the reclocking is successful, the RCLK LED will be
green and the 540 Mb/s LED will be yellow
If the reclocking is not successful, the RCLK LED will
be red, the 540 Mb/s LED will be off, and
un-reclocked data will be present at output
HD
(see
Figure 3-1
on page 16 for a picture of the jumper
set settings)
Set the jumper on the pin that allows the reclocker to
handle HD (1.485 Gb/s) data only
If the reclocking is successful, the RCLK LED will be
green and the HD LED will be yellow
If the reclocking is not successful, the RCLK LED will
be red, the HD LED will be off, and un-reclocked
data will be present at output
