Harris ADC 100, User Manual

Page: 34 / 128

Harris ADC Device Server User’s Guide
1-6 Installation
Installing the Configuration Software
NOTE:
The configuration software is installed on any client on the Harris
network, NOT on the device server. If you already have a floppy diskette
containing the files, skip to step 3.
1.
Copy the config.exe file to a temporary directory. This file is a self-extracting zip file.
2.
Copy the extracted files onto a floppy diskette and label it “ADC NT Configuration.”
3.
Insert the floppy disk into the client’s floppy drive.
4.
Open a command prompt and type a:setup.exe to begin the installation.
5.
InstallShield proceeds to install the software onto the client. Follow the onscreen instructions
to complete the installation.
6.
Enter a password when the following screen appears during installation:
Make sure to remember the password you enter. You will be required to re-type the same
password on the next screen to confirm your password choice. If you forget the password or if
it becomes compromised (i.e., the proper password no longer works), you must re-install the
configuration utility.
CAUTION!
After installation is complete, store the floppy disks in a safe place. If
you installed from a temporary directory on your hard drive, make
sure to delete the temporary directory.
If these files are left on the
computer, anyone can override the password by simply reinstalling
the configuration software and entering a new password.