GB
4
앫
3 mm socket-head wrench
앫
4 mm socket-head wrench
앫
Open-end wrench, jaw width 13
앫
Crosshead screwdriver
앫
Plumb line
앫
Flat screwdriver
앫
Spirit level
앫
Handtruck
앫
4 S6 plugs and 4 stucco screws
(included)
앫
1 selfdrilling parker (provided and
1 spare)
앫
Sliding pieces
앫
M-5 bolts (included)
앫
Grease (molycoat)
Materials and tools required
2. Ceiling or wall connector
앫
Fasten the ceiling plate using the plugs and stucco
screws provided.
앫
Level it (A).
앫
Determine the heart of the smoke outlet by using
the plumb line.
3. Placing the stove
앫
Adjust the smoke outlet pipe at the right lenght.
앫
Rub the inside of the outletring (A) and the connec-
tionring (B) with grease and telescope into each other.
앫
Slide the stove into position using the sliding pieces.
Make sure that you don’t damage the floor.
앫
Remove the packaging.
General instructions and directions
앫
The installation of the Signa must be carried out by a skilled person employed by a dealer recognized by Harrie
Leenders Haardkachels.
앫
The casing parts are susceptible to scratching. Handle them gently.
앫
After the stove has been properly installed, burn some kindling wood to check the draught.
Safety recommendations
앫
Glass tends to break easily, and broken glass is quite sharp. Take therefore adequate safety precautions.
앫
For general safety, we refer to guidelines or regulations issued by a relevant official body.
1. Transportation
앫
Remove the door and put it away safely.
앫
Styrofoam or packing bolster between the stove and
the hand truck for protection.
앫
Transport the stove with it's front against the hand
truck.
앫
Don’t remove the packaging yet.
handtruck
Styrofoam
stove (still
in packaging)
A
A
B
A
