Harper 5400, Operator'S Manual

Page: 9 / 38

Chipper/Shredder
R
R
CS-5400 PTO Powered Model
• Never operate the PTO unit when trac-
tor is moving. Machine should only be
operating when setting level on ground
surface.
• To move the unit, shut the PTO off. Lift
the 3-point hitch, and then move to the
desired location.
• Keep hands, feet and clothing away
from PTO driven parts.
• Keep all guards and shields in place
during operation. Disengage PTO and
shut off the engine before removing
guards or shields.
• Never attempt to adjust, clean or lubri-
cate the machine while it is in opera-
tion.
• Operator should never wear loose
clothing when working around PTO.
• Before starting tractor, make sure that
the transmission and PTO are disen-
gaged.
• A belt between the PTO shaft and the
rotor shaft drives the cutting blades
whenever the PTO shaft is turning.
SAFETY WARNING!
Recommended tractor PTO horsepower is
18 to 30 HP. Use of tractors above 30 HP
may cause belt damage and will void war-
ranty.
SAFETY WARNING!
Cutting blade rotation cannot be con-
trolled from the Chipper/Shredder.
CS-1800 Gas Powered Model
Engine
• Be certain to provide adequate ventila-
tion if an engine must be run indoors -
exhaust fumes are dangerous.
• Periodically clean chopped material
away from engine to lessen the possi-
bility of fire.
• Always keep a fire extinguisher near
the Chipper/ Shredder during opera-
tion.
• Engine governor settings are pre-
set and should not be changed; any
change can damage moving parts and
void the warranty.
• Keep clothing and all body parts away
from rotating parts.
Towing
• A 2” ball is required to tow this unit.
Make sure bolts holding tongue are
secure and always use a safety chain.
• When towing, travel at speed safe for
conditions. Do not exceed 30 mph.
Always have jack in transport position.
• Tire pressure should be 60 psi. Make
sure all wheel lug nuts are tight.
SAFETY WARNING!
Gasoline is extremely flammable and can
be highly explosive. To minimize the dan-
ger:
• Always use an approved container for
gasoline.
• Do not allow open flames or sparks
while performing maintenance or
refueling.
• Never remove the fuel tank cap or add
gasoline when the engine is running or
hot.
• Refer to Engine manual for additional
information on gasoline.
Specific Safety Guidelines
7