Harmopool Hydrolyse EC20, Manual

Page: 31 / 31

31
LED8 flashes
Te weing salt
Too little salt in the water
The salt is not dissolved Add salt if necessary
Deposits or foreign objects
cause flooding Clean the cells
The electrolytic cell is worn
out Replace the cells
Led9 flashes
Too much salt Too much salt in the water No action prepares or really too much,
diluting water
Deposits or foreign objects
in the cell that cause
excessive flow. . Clean the cells
Led7 flashes
No water flow excess gas in the electrolyseal.
this may be because the pump
was turned off. the gas is
hydrogen that is highly
flammable Remove the accumulated gas from the
cell. Turn the lid open for a quarter and
let the gas escape. Check the pipes for
accumulated gas. Check the pump.
Cell sensor cable is
defective or wrongly
connected (white wire) Check the sensor cable (white cable)
Cell sensor is dirty Clean up (seemaintenance))
Too little of no water flow Check the flow
LED6 flashes
Overload The cell is wrongly
connected Check wiring. Contact your supplier.
Metal parts in the cell Turn off the device and remove the
metal object from the cell
Led5, led4, led3,led2
De 4 produktie-LEDs (%)
blinking
(Open circuit) Cell wrongly connected Check the cell connections and make
sure that the condition of the terminals
and and cable are in good condition.
The cell is damaged or worn
out Check the cell electrodes and swap them
if they are damaged
Pool water with very low
salinity Check the out of the water and make
sure everything salt is completely
dissolved