Harmony Vybe Deluxe, Instruction Manual

Page: 20 / 27

2 0
Headrest HeigHt adJUstMents #5 - #8 can Be Used in Booster
Mode
(42)
.
! recline cannot Be Used in Booster Mode
(43)
.
1. Place the booster seat flush against a forward-facing vehicle seat. The vehicle
seat MUst be equipped with a 3-point lap-and-shoulder belt. Booster must be
level, stable and not rock side-to-side.
2. Place child in the booster seat with child’s back flat against the back of the
booster seat.
3. Adjust headrest height so that the bottom of the headrest is eVen with or JUst
aBoVe the shoulders (see “Headrest height adjustment”).
4. Thread the vehicle shoulder belt portion of the seat belt through the backrest belt
guide on top of backrest
on tHe saMe side
as the seat belt retractor
(44)
and ensure that shoulder belt lies across child’s shoulder and chest, and
not
across child’s face or neck.
5. thread both sides of the lap belt over lower guides on both sides as
indicated
(44)
. ensUre that the belt is snug across the child’s hips. it
is important to ensure that any lap strap is worn low down, so that the
pelvis is firmly engaged, just touching their thighs and is not across their
stomach.
Warning!
!
! alWaYs ASSIST YOUR CHILD WHEN GETTING INTO AND OUT OF THE CHILD
REstRAInt/BoostER sEAt .
! ensUre THAT THE CHILD RESTRAINT Is LEVEL, stABLE AnD DoEs not
ROCK SIDE-TO-SIDE. IF THE CHILD RESTRAINT Is not stABLE, tRY AnotHER
SEATING LOCATION.
! do not add anYtHing BeHind or Under tHe cHild restraint.
installing WitH V e H i c l e s e at B e lt
g r o U P 2 & 3 ( 1 5 - 3 6 Kg )
Warning!
!
dUe to VarYing angles oF VeHicle seat Belt retractors,
excess slacK in tHe VeHicle Belt sYsteM MigHt not Be reMoVed
aUtoMaticallY.
Once the lap and shoulder portions of the seat belt are
properly positioned and the buckle is attached,
Feed anY reMaining
slacK oF tHe seat Belt ManUallY BacK into tHe retractor to
tigHten tHe WHole sYsteM.